TXXI IK 0,6/1 kV 4G25 mm² AFR New
Country ref. 1007475
StandardsInternational : HD 603.5J;IEC 60332-1-2
Power distribution cable, designated for road lights, entry point installation or other general outdoor use (UV-resistant).
The cable is fire-retardant and halogen free, each phase having insulation and an outer sheath.
Can be placed directly in soil, and in water if it is not exposed to additional mechanical stress.
When laying at a lower temperatures than 0 degrees Celsius, care must be taken to avoid damage to the outer sheath. It is especially important that the cable is not exposed to impact at temperatures below 0 °C.
When laying at lower temperatures than -10 degrees Celsius, the cable should be preheated before laying as well.
If the cable is cut and not installed immediately, each phase must be sealed, to prevent water intrusion.
|Type of conductor||Circular compacted stranded|
|Outer sheath||Halogen free, fire retardant|
|Diameter over insulation||7.6mm|
|Nominal outer diameter||24.0mm|
|Number of cores||4|
|Max. DC resistance of the conductor at 20°C||1.2Ohm/km|
|Perm. current rating buried 15°C - trefoil formation||105A|
|Perm. current rating in air 25°C - trefoil formation||125A|
|Maximum operating voltage||1000V|
|Permissible short circuit current||2250A|
|Maximum pulling force by laying||3.75kN|
|Minimum installation temperature||-10°C|
|Flame retardant||IEC 60332-1-2|
|Bending factor when laying||6(xD)|
|Max. conductor temperature in service||90°C|