StandardsInternational : IEC 60708; IEC 61156
The cable consists of plain, annealed copper conductors with foamed polyethylene (PE) insulation. The cable core is filled with petroleum jelly and wrapped with polyester tape. The inner sheath material is PE.
The cable is screened with one layer of aluminium wires and one layer of semi-conductive tape. The cable core is then armoured with two layers of steel tape. A polyethylene outer sheath is then applied.
Information on electrical data, as well as cable core design and identification, is attached below.
|Type of conductor||Circular, solid|
|Material used for longitudinal water tightness||Grease|
|Screen||Aluminium wires and semi-conductive tape|
|Armour type||Steel tapes|
|Number of pairs||10|
|Nominal outer diameter||24.0mm|
|Minimum breaking load||5kN|
|Maximum pulling force by laying||3kN|
|Maximum tensile load during service (Tl)||100.0daN|
|Minimum static operating bending radius||240mm|
|Operating temperature, range||-40 .. 60°C|
|Ambient installation temperature, range||-15 .. 40°C|
|Storage temperature, range||-40 .. 70°C|