StandardsInternational : EN 50265; IEC 60332-1
Control cable for indoor and outdoor use. May be installed directly in-ground.
Suitable for signal installations etc. Where a screened cable is required
May be used indoors, outdoors and in the ground.
These cables are normaly in stock. Provided suitable fabrication length, the cable may be produced after customer request with other number of conductors and cross sections than the once stated in the table.
The insulation is white with black number marking.
Bedding/Tape: 5 - 7 conductors : Bedding
Remaining : Tape
Marking on the outer sheath:
Cabletype, voltage, no. of conductors and cross section.
If the cable is cut outdoor, any end(s) must be sealed if not connected/terminated. This to prevent water intrusion, and possible corrosion in the future.
|Core identification||Black numbers|
|Conductor material||Bare annealed copper stranded|
|Type of conductor||Circular, solid|
|Flame retardant||IEC 60332-1|
|Max. conductor temperature in service||70°C|
|See all products|